Professional Manufacturer For All kinds Of Beverage Equipment

How to adjust the set of marking machine automatically

by:Xinmao     2021-06-02
At present, the automatic set of marking machine is widely used in all kinds of bottle of juice, tea drinks, dairy products, pure water, condiments, beer, sports drinks and other food and beverage industry, the applicability is wide and set the position degree is high, by the vast number of enterprise customers consistent high praise, in use process, however, more work in order to make the set of marking machine, there are some matters needing attention are worthy of our attention, in this paper, from the set of marking machine automatically using considerations in detail for you. Automatically set of marking machine when using should be from four aspects to adjust equipment. 1, labels, the adjustment of the box. Standard box of centerline, standard station central axis and label paper and tangent, the plate central axis into a line of three, to adjust the plate and label paper tangent ( Zero distance) And then move the box near 1 mm ~ 2 mm. On both sides of the paper in the box and layering of the clearance should be 0. 8mm- Between 1 mm, clearance is too large to cause the paper in the box shift, appear inclined, push gap is too small will cause the confusing. The box to grasp the regulation of the hook position: the up and down, left and right sides of the hook in the same vertical plane and even demanding in the paper, can grasp the smoothly. Label supply roller to adjust: when there is no label, tag clamp to pressure box zui front-end and tagged tag near the hook refers to cannot be crushed. 2, press brush device adjustment. Mark the center of the brush to label and balanced on both sides. The brush is perpendicular to the surface of the container. Pressure brush sweeping container for overlap: a single pressure brush to 10 mm to 15 mm, brush combination pressure for 5 mm to 10 mm. The location of the sponge cleaning brush distance is 1 mm ~ 2 mm. The adjustment of the pressure bottle. Pressure bottle without the bottle should be 20 mm lower than with the bottle. 3, adjustment of the station. Scraping rubber sheet and rubber roller adjustment: a rubber sheet and rubber roller cannot appear over the whole length of clearance, if there is a gap can by adjusting the eccentric bolt to adjust the scraping rubber sheet. Rubber roller and standard plate: the regulation of standard plate and rubber roller between just touch each other without any pressure. Excess clearance is too large, the plate glue, glue. Gap is too small, contact too tight, the glue will be crowded go, half the board without glue. Practice has proved that the gaps between the roller and at zero. 1毫米~ 0。 For zui between 2 mm. Can be done by adjusting the rubber roller lower bearing seat, was carried out on the upper part of the rubber roller bearing adjustment when necessary. 4, into the bottle of star wheel, and a bottle of star wheel and screw into the bottle. On into and out of the bottle of star wheel and screw into the bottle to adjust, will be subject to pressure bottle labeling machine. Firstly adjust into the bottle of star wheel, when pressure bottle head just over the bottle, adjust into the bottle of star wheel, make the bottle is located between the star wheel groove. Bottle feeding screw adjustment: will be subject to into the bottle of star wheel, and when the bottle in the bottle of star wheel groove right in the middle, the adjusting screw, the screw into the bottle of lateral displacement generated by tight bottles but not. A bottle of star wheel adjustment: when the pressure bottle just raise head, adjust the star wheel to make the bottle in the middle of star wheel groove. In addition to the above points, we are in the process of daily use, should also pay attention to automatic marking machine maintenance, so as to improve the work efficiency and prolong the service life of the machine!
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...